scalby

Volume and Remote Backlight Option HACK for MZ-NH600 (may work on other models too (ie) MZ-NH700 – 800 – 900) READ BOTH PART ONE AND PART TWO BEFORE YOU START Part 1 Entering the service mode is possible by following these instructions: Remove the MD if inserted and unplug earphones and or remote, close the lid. Set the "HOLD" switch to ON. While holding down the GROUP key, enter this key sequence: >>| >>| |<< |<< >>| |<< >>| |<< | | | | i.e. FF FF REW REW FF REW FF REW PAUSE PAUSE RELEASE ALL KEYS. If you have successfully entered service mode, the display will alternately display the firmware version in the left display and a screen with all LCD segments lit at about half second intervals. That’s it! Don’t change any settings unless you know what you are doing!!!!!!!!!!! Leave the service mode by removing the battery!!! Part 2 First if you are stuck, just press stop several times until you get back to the service mode flashing screen . Here goes the sequence after the flashing service mode screen: (Key | Display) VOL+ | 0 Manual FWD | 100 MT FWD | 110 NV FWD | 111 xxxSCC (xxx values counting up...) FWD | 112 NoClock FWD | 113 xxxS25 (xxx values counting up...) Now to change the value after S just use VOL+ to increase and VOL- to decrease (in my case it was set as A0, so I just pressed VOL- until I read 25) Press PAUSE to save Then press stop till you get to the first menu, with the flashing screen. To quit the service mode, remove all the power sources from the unit. Remove battery and / or AC adaptor plug. Replace the battery and the unit should start as normal . On my unit with a RM-MC35ELK remote the Option menu on the remote now includes Backlight adjustments (Auto-On-Off). MZ-NH600 US - (Not a US model??) Canadian/Australian 20 Europe/UK A0 Hong Kong/Korean 25 E91/Mexican 20

Hi,http://forums.minidisc.org/index.php?showtopic=7434 this is a better link and easier to follow to get your remote Backlight to work. Look at the first two messages, for instructions.

Hi, I have a MZ-NH600 with a RM-MC35ELK remote with backlight. When I first got it, it only lit up at the start for about 10 seconds, then would only light up when I pressed a button or changed the volume. I now know that this is auto mode. I too did not have access to the Backlight option, until I was doing the HACK to raise the output volume. This is availible in the technical section. I changed line 113 to 25 and not only did it raise the volume but the Option for Backlight is now availible on the remote. Here is the link. http://forums.minidisc.org/index.php?showtopic=5

Yes the can br erased. As page 49 and 50 in the manual.

I have a MZ-NH600 and the way to add T Marks is with the larger button to the left of the pause button. The way I do it is after I have recorded something I listen to it and add the track marks at that end of each track . Or watch the timer and then rewind and play again so that you can mark it at that timer place. Good Luck