Hebe22 Posted 6 hours ago Report Share Posted 6 hours ago Good morning everyone, I am writing to get other opinions on this problem: I installed the FlyMotion electronics controlled by Mach3, I configured the parameters given to me by the manual, the movement part consists of a Nema 34 12nm motor with a 1000 resolution encoder, the ACME screw motor connection is through a 2-partition pulley, the pitch of the screw when moving I first tried to connect the axis, then tried to use the free motor, because I thought it was a problem of undersized motors, but at this point all three motors were broken, probably the driver was broken too, the only problem was the polarity of the connector, so I ask how to find it on the motor? The wiring diagram for the motor shows the pins, but not the wire colors. Motor and driver: https://www.oyostepper.com/goods-468-1-Axis-Closed-Loop-Stepper-CNC-Kit-130Nm-1841ozin-Nema-34-Motor-Driver.html Quote Link to comment Share on other sites More sharing options...
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.