helgawb Posted April 5, 2015 Report Share Posted April 5, 2015 HI - I have a dreaded EE Error on a RH1 - it was put into service mode previously and presumably parameters were changed. I can get it into service mode again, but of course do not know what the default settings were. I found a reference to a thread which contained the information,("a search would have shown that the sequence is up on MDCF already (check this thread)") - but the thread/settings are no longer there. Does anyone out there have any information? Its like looking for the Holy Grail..... Quote Link to comment Share on other sites More sharing options...
sfbp Posted April 5, 2015 Report Share Posted April 5, 2015 Not a chance, you MUST do an alignment now, almost certainly. It's possible that setting the state byte to FF may do it (1931?) but I wouldn't want to warranty the results myself. Quote Link to comment Share on other sites More sharing options...
punkrockaddict Posted April 6, 2015 Report Share Posted April 6, 2015 IS that the same unit we have discussed before ? that was dropped down a table or something ? Or where the kids played with ? Quote Link to comment Share on other sites More sharing options...
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.