febed01 Posted January 10, 2012 Report Share Posted January 10, 2012 Hi, My Sharp MT-877 got stuck after fooling around with the test mode (yeah, I souldn't have but it didn't arrived to me in a good condition anyway, so I didn't risk much). Now it just shows an error "Md-Er80". Is there a way to re-initialize it to factory settings ? Thanks Quote Link to comment Share on other sites More sharing options...
sfbp Posted January 10, 2012 Report Share Posted January 10, 2012 It's called "doing an alignment", I think. However I am not sure how the Sharp units behave, as I don't have any service manuals. Jim may know. Quote Link to comment Share on other sites More sharing options...
jim.hoggarth Posted January 14, 2012 Report Share Posted January 14, 2012 I have done the realignment routines on a couple of Sharp units, but not this particular model. These were the MD-MT190 and MT200. To be honest, I can't remember even how to get into service mode, but it is documented. Alignment is not as simple as for Sony models. It is very convoluted, and the Sharp manuals are abysmal - I read them as if they are 'reminder notes' handed out at a full service briefing. That is, the engineers are taken through the concepts and the required steps, but the manuals are written in a kind of shorthand only understandable by the privileged few! I may be able to look at it for you, but I doubt I could walk you through the routines without having an MT877 - which I have not. And you will need the right discs. And it is possible you have changed a setting that can only be reset with special tools or knowledge, although I doubt this. But I have never taken a Sharp down to a 'blank' EEPROM and always started with one that is (or was) working and that has not been tinkered with. Whereabouts in the world are you? Jim Quote Link to comment Share on other sites More sharing options...
febed01 Posted January 16, 2012 Author Report Share Posted January 16, 2012 Hi, and thanks for answering I live in the close neibourhood of Paris, France. I'll try to at least get into the test mode again, but if special tools or disk are needed to reset the thing, then I think I'll have to face the consequences of beeing too carefree while fooling around with dangerous games and accept the fact that it's dead Quote Link to comment Share on other sites More sharing options...
jim.hoggarth Posted January 19, 2012 Report Share Posted January 19, 2012 Hi again febed01. Do you want to send it to me to see what I can do? I am unsure how much air mail post is for you to send to me, but return postage is around 3.00 GBP for just the unit on its own (no accessories required). If so PM me with your email address and I will send you my postal address. It will not cost much to do - I may even be able to fix it for nothing if it is a simple job. I would just need reimbursing for costs. Jim Quote Link to comment Share on other sites More sharing options...
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.