bonbonneke Posted December 13, 2015 Report Share Posted December 13, 2015 Hello , On my previous windows 8.1 sonic stage ande RH-1 did work fine, After upgrading to windows 10 ..... problems.... Pc sais, no drivers found, I downloaded NETMD 052 & NETMD 760 from this site but without any luck, Does any one has a clue how to proceed? thanks from The Netherlands Quote Link to comment Share on other sites More sharing options...
azwris Posted December 13, 2015 Report Share Posted December 13, 2015 hi bonbonneke, Sonic Stage 4.3 works fine on my Win 10 64 with MZ-RH1. Maybe it's the upgrade procedure that's causing an issue. I have installed my Windows 10 from scratch. Have you tried to make a clean re-installation of Sonic Stage? 1 Quote Link to comment Share on other sites More sharing options...
bonbonneke Posted December 13, 2015 Author Report Share Posted December 13, 2015 HEllo Azwris, I wanted do do that too , but actually windows 10 worked fine except for sonic stage, I will try to reinstall again , but the problem is that if I connect the Rh1 windows doesn't recognize it and says there are no drivers for it ( does it need a driver as far as you know?) thanks for your reply! Quote Link to comment Share on other sites More sharing options...
sfbp Posted December 13, 2015 Report Share Posted December 13, 2015 You have to disable driver signing. It's been written down in many places. I think it's something like Shift-Start in W10. But the common technique to all versions of Windows after XP is to hit <f8> during boot and look for something that allows you to turn it off temporarily. There's one more issue yet here. The "DISC MODE" of your RH1 is important, and is either MD or Hi-MD. This is the mode that the computer will see when the unit has NO disk in it. If you only use HiMD formatted disks then you have no problem, set the DISC MODE to Hi-MD and be happy. However if you need NetMD for uploads and so on you will need the 64-bit NetMD driver from our downloads section. I'm guessing your RH1 is defaulting to MD "DISC MODE". Quote Link to comment Share on other sites More sharing options...
bonbonneke Posted December 13, 2015 Author Report Share Posted December 13, 2015 thanks !! this worked so the solution is to disable driver signing and after that add your driver , then it works , thanks again ! Quote Link to comment Share on other sites More sharing options...
azwris Posted December 14, 2015 Report Share Posted December 14, 2015 by the way I had the same issue regarding my NetMD discs. I gave up at a certain point but I will try now your solution sfbp. I'm glad it worked for you bonbonneke! :) Quote Link to comment Share on other sites More sharing options...
bonbonneke Posted December 14, 2015 Author Report Share Posted December 14, 2015 I hope it will work for you too !! so the working driver for me was NETMD 760 , good luck! Quote Link to comment Share on other sites More sharing options...
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.